Payment Options: Money Order, Cashier's Check, Personal Check,
Imagine being able to put a wall switch anywhere you like, without running wires or cutting a hole in your wall. It’s easy with this attractive, super thin, light-weight Wireless X10 Wall Transmitter Module. It adheres to any surface with its included double-side tape. With easy, single push-button programming, you have wireless remote control of up to 3 each X10 Receiver Modules on consecutive X10 addresses (i.e. - A1, A2, A3), plus Dimming capability with the fourth button. This attractive Wireless X10 Wall Switch measures only 1/4 inch thick and is white in color. The X10 Wall Transmitter uses a thin 3-volt lithium battery (included).
CR2032 3V Battery (supplied), PAT01 - RF Base Transceiver Module sold separately.
Optional / Supplementary Devices & Modules:
PLW01 Standard Incandescent Wall Switch Module, PLM01Plug-in Lamp Module, PAM01/02 Plug-in 2 and 3-pin Appliance Modules.
House Code Dial - Letters A-P, Default "A" Unit Number Dial - Numbers 1-16, Default "1"
Each X10 Receiver Module is set to a unique Unit Number or to an identical Unit Number as desired.
Each X10 Controller operating a specific set of Receiver Modules must be set to the same House Code as the Receivers they are controlling.
Nearly all residential homes are wired SPLIT-PHASE. Each 120V Phase is NOT directly connected with the other 120V phase. If after installation,
an X10 Receiver does not respond to a remote Controller, then check to ensure that the breaker serving the X10 Receiver is on the same phase as
the Controller. If not, the breaker can be changed to the opposite phase. An alternative solution is recommended, to install a Phase Coupler for
improving remote communications throughout the home. See www.x10pro.com, then select Technical Support and PLC Troubleshooting.
1. Attach the PHW04D to a wall using supplied double sided tape. If you want to control Modules 1, 2 and 3 on Housecode A, you don't need to
read any further. For programming changes see next page.
2. Plug in and set the (PAT01) RF Base Transceiver's House Code Dial to match the House Code on the RF Handheld Remote that will be used.
3. Set the UNIT Slide Switch to "1" to control the built-in Outlet, from a Wireless Transmitter or Controller sending an X10 "A1" Command, or set the
Switch to "9" to control the built-in Outlet with an X10 "A9" Command. The UNIT Slide Switch has no effect on control of all 16 Unit Numbers from
an X10 Wireless Remote.
You are now able to operate your installed X10 Receiver Modules installed throughout the home by pressing the appropriate button ON or OFF on
the Remote that corresponds to a specific Module. If that Module is a dimming Module, then a Bright or DIM Command can be pressed after the
initial ON Command telling the Module to adjust its intensity level.
To turn "ON/OFF" X10 PRO Modules, set them all to Housecode "A" and Unit Codes 1, 2, or 3. Press the ON or OFF of the first, second or third
rocker keys to operate the X10 Receiver Modules. To Brighten/Dim a Lamp Module or Wall Switch Module, press the desired Module Unit Button
ON first, then press and the Bright or Dim side of the bottom rocker key.